Konica Minolta CM-2600d Instruction Manual page 88

Assessments
5
If they are satisfactory, turn B to select "BREAK", then press A.
The measurement screen will ap-
pear.
6
Place the specimen measuring port to the specimen, and then press C (MEAS.
button).
The color difference from the target color, pass/fail judgment result based on the specified box tolerances
and direction of tint and brightness deviation will be displayed.
• The color space to be used as the assessment axis differs depending on the selected color space.
When "L*C*h,
ment will be made based on the direction of tint and lightness deviation and color difference from the
target color in the L*C*h axis.
When a color space other than those given above is selected, assessment will be made based on the
direction of tint and lightness deviation and color difference from the target color in the L*a*b* axis.
M
emo
• Assessment results differ as shown in the table below depending on the type of specified color difference toler-
ances and pass/fail judgment result.
Type
Box
tolerance
Elliptical
tolerance
E-86
E", "L*C*h, CMC1:1", "L*C*h, CMC2:1" or "L*C*h, CIE94" is selected, assess-
Specular
Displayed value
component
Color difference
I+E
E*
Color difference
SCI or SCE
E*
Color difference No judgment
I+E
SCI or SCE
E*
Pass/fail
judgment
PASS Measured value, with "PASS" to the right
Highlighted measured value, with highlighted
FAIL
message to the right
PASS Measured value, with "PASS" to the right
Highlighted measured value, with highlighted
FAIL
"FAIL" to the right
PASS Measured value, with "PASS" to the right.
Highlighted measured value, with highlighted
FAIL
"FAIL" and message to the right
PASS Measured value, with "PASS" to the right
Highlighted measured value, with highlighted
FAIL
"FAIL" to the right
Measured value, with message to the right
PASS Measured value, with "PASS" to the right
Measured value, with highlighted "FAIL" to the
FAIL
right
Display content