Bosch AutoDome Junior HD VJR Series Operation Manual page 71

AutoDome Junior HD Series
–
–
–
–
–
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
Caution!
The profiles are rather complex. They include a large number of parameters that interact with
one another, so it is generally best to use the default profiles.
!
Change the profiles only once you are fully familiar with all the configuration options.
In the default setting, Stream 2 is transmitted for alarm connections and automatic
connections. Bear this fact in mind when assigning the profile.
Notice!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
Profile name
You can enter a new name for the profile here. The name is then displayed in the list of
available profiles in the Profile name field.
Target data rate
You can limit the data rate for the AutoDome Junior HD to optimize utilization of the
bandwidth in your network. The target data rate should be set according to the desired
picture quality for typical scenes with no excessive motion.
For complex images or frequent changes of image content due to frequent movements, this
limit can be temporarily exceeded up to the value you enter in the Maximum data rate field.
Maximum data rate
This maximum data rate is not exceeded under any circumstances. Depending on the video
quality settings for the I- and P-frames, this fact can result in individual images being skipped.
The value entered here must be at least 10% higher than the value entered in the Target data
rate field. If the value entered here is too low, it will automatically be adjusted.
Video resolution
Here you can select the desired resolution for the video image. The following resolutions are
available:
Bosch Security Systems, Inc.
Maximum bit rate: 1500 kbps
Encoding interval: 30.00 ips
DSL Target bit rate: 400 kbps
Maximum bit rate: 500 kbps
Encoding interval: 30.00 ips
ISDN (2B) Target bit rate: 80 kbps
Maximum bit rate: 100 kbps
Encoding interval: 30.00 ips
ISDN (1B) Target bit rate: 40 kbps
Maximum bit rate: 50 kbps
Encoding interval: 30.00 ips
Modem Target bit rate: 20 kbps
Maximum bit rate: 22 kbps
Encoding interval: 15.00 ips
GSM Target bit rate: 7 kbps
Maximum bit rate: 8 kbps
Encoding interval: 7.50 ips
Operation Manual
Configuring the AutoDome Junior HD | en
2014.11 | 6.1 | F.01U.275.803
71