Pixel Counter; Advanced Mode: Recording; Storage Management - Bosch AutoDome Junior HD VJR Series Operation Manual

80 en | Configuring the AutoDome Junior HD
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data are encoded according to G.711 and require an additional
bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be
transmitted, select Off.
Line In
You can set the line input gain. Make sure that the display does not go beyond the green zone
during modulation.
Record Format
Select a format for audio recording. The default value is G.711. Select L16 if you want better
audio quality with higher sampling rates. This requires approx. eight times the G.711
bandwidth.
12.31

Pixel Counter

Counts the number of pixels in a defined image area. The pixel counter allows the installer to
easily verify that the camera installation fulfills any regulatory or specific customer
requirements, for example, calculating the pixel resolution of the face of a person passing a
doorway monitored by the camera.
12.32

Advanced Mode: Recording

12.33

Storage Management

You can record the images from the AutoDome Junior HD on various local storage media or on
an appropriately configured iSCSI system.
It is also possible to let the VRM Video Recording Manager Control all recording when
accessing an iSCSI system. This is an external program for configuring recording tasks for
video servers. For further information please contact your local customer service at Bosch
Security Systems, Inc.
Device manager
If you activate the VRM option in this screen, the VRM Video Recording Manager will manage
all recording and you will not be able to configure any further settings here.
Caution!
Activating or deactivating VRM causes the current settings to be lost; they can only be
!
restored through reconfiguration.
Recording media
Select the required recording media here so that you can then activate them and configure the
recording parameters.
iSCSI Media
If you want to use an iSCSI system as a recording medium, you must set up a connection to
the required iSCSI system and set the configuration parameters.
Notice!
The iSCSI storage system selected must be available on the network and completely set up.
Amongst other things, it must have an IP address and be divided into logical drives (LUN).
1.
2.
2014.11 | 6.1 | F.01U.275.803
Enter the IP address of the required iSCSI destination in the iSCSI IP address field.
If the iSCSI destination is password protected, enter this into the Password field.
Operation Manual
AutoDome Junior HD Series
Bosch Security Systems, Inc.