Network/Bluetooth - Pioneer SC-LX901 Basic Manual

> Specifications > Settings

Network/Bluetooth

Make settings related to network connections and BLUETOOTH .
Operation:
Use the on-screen displays (OSD) that appear on the TV to make the settings.
Press on the remote controller to display the Home screen, select Network/Bluetooth
with the cursors on the remote controller, then press ENTER.
Select the item with the cursor / / /
ENTER to confirm your selection.
Use the cursors / to change the default values.
• To return to the previous screen, press
• To exit the settings, press
.
44
> Listening Modes > Playback Function
buttons of the remote controller and press
.
Network
• When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting
automatically. ("Enable" is set by default.) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item Default Value
Wi-Fi Off (Wired)
-
Wi-Fi Setup
-
Wi-Fi Status
-
MAC Address
DHCP Enable
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway 0.0.0.0
DNS Server 0.0.0.0
-
Proxy URL
Proxy Port 8080
> Basic Manual
Troubleshooting | Appendix
Setting Details
Connect the unit to network via wireless LAN
router.
"On": Wireless LAN connection
"Off (Wired)": Wired LAN connection
You can configure wireless LAN settings by
pressing ENTER when "Start" is displayed.
The information of the connected access point will
be displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access
point.
"Status": Status of the connected access point.
This is the MAC address of this unit.
This value is specific to the component and cannot
be changed.
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
• If selecting "Disable", you must set "IP Address",
"Subnet Mask", "Gateway", and "DNS Server"
manually.
Displays/Sets the IP address.
Displays/Sets the subnet mask.
Displays/Sets the gateway.
Displays/Sets the primary DNS server.
Displays/Sets the proxy server URL.
Displays/Sets the proxy server port number when
you enter "Proxy URL".