Pioneer SC-LX901 Basic Manual page 72

> Specifications > Settings
Setting Item Default Value
Subwoofer 0.0dB
36
> Listening Modes > Playback Function
Setting Details
Control the effect of standing waves for the
subwoofer.
1. After selecting "Filter" with / , select the filter
to be adjusted from "1" to "3" with
press ENTER.
2. After selecting the central frequency with
/ , adjust the bandwidth with /
adjust the attenuation with / . The central
frequency can be selected between "63Hz"
and "250Hz". The bandwidth can be selected
between "2.0" and "9.8" (0.2 intervals).
Attenuation can be selected between "0.0dB"
and "12.0dB" (0.5dB intervals).
■ EQ Adjust
You can adjust the output volume of the range of each speaker while listening to test
noises. You can adjust the volume of the different sound ranges for each of the speakers.
You can select up to four bands for the Subwoofer and nine bands for all other speakers.
If the overall volume balance changes by adjusting the volume of each frequency, you can
and
/
readjust the balance in "Trim".
, then
Setting Item Default Value
Front Left 0 dB
Center 0 dB
> Basic Manual
Troubleshooting | Appendix
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "−12.0 dB"
and "＋12.0 dB" (in 0.5 dB intervals) with
To readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "−12.0 dB"
and "＋12.0 dB" (in 0.5 dB intervals) with
To readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
/ , adjust
/ .
/ , adjust
/ .