Pioneer SC-LX901 Basic Manual page 64

> Specifications > Settings
■ Zone 3
Setting Item Default Value
Output Level Fixed
Volume Limit Off
Power On Level Last
Bass 0 dB
Treble 0 dB
Balance 0
28
> Listening Modes > Playback Function
Setting Details
Select whether to adjust the volume on the pre-
main amplifier in the separate room or on this unit
when outputting to Zone 3.
"Fixed": Adjust on the pre-main amplifier in the
separate room
"Variable": Adjust on this unit
Set the maximum value for Zone 3 to avoid too
high volume. Select "Off" or a value between "−32
dB" and "＋17 dB".
Set the Zone 3 volume level of when this unit is
turned on. Select a value from "Last" (volume
before the unit was turned off), "− dB", and "−
81.5 dB" to "＋18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Adjust the volume of the bass for Zone 3. Select a
value between "−10 dB" and "＋10 dB".
Adjust the volume of the treble for Zone 3. Select a
value between "−10 dB" and "＋10 dB".
Set the left-right balance for Zone 3. Select a
between "L ＋ 10" to "R ＋ 10".
Miscellaneous
Change the frequency step for the tuner, update the firmware, and perform Initial Setup,
etc.
■ Tuner
Setting Item Default Value
AM / FM 10 kHz / 0.2 MHz Select a frequency step depending on your area of
Frequency Step
(North American
models)
AM Frequency 9 kHz
Step (European
and Asian
models)
AM Noise Cut 1
Mode
> Basic Manual
Troubleshooting | Appendix
Setting Details
residence.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets
are deleted.
Select a frequency step depending on your area of
residence.
Select "10 kHz" or "9 kHz".
• When this setting is changed, all radio presets
are deleted.
You can improve reception sensitivity by changing
this mode if you are finding AM broadcasts difficult
to hear. Select "1" or "2".