Pioneer SC-LX901 Basic Manual page 78

> Specifications > Settings
Setting Item Default Value
Surround Right -
Surr Back Left -
Surr Back Right -
42
> Listening Modes > Playback Function
Setting Details
Move the speakers back and forth about a
centimeter at a time in relation to the speaker
setup microphone so that "Score" becomes "10.0"
If the number does not become "10.0", put the
speaker in the position where the maximum value
is achieved.
• Do not move the Front Right speaker,
upon which calibration is based, during the
adjustments.
Move the speakers back and forth about a
centimeter at a time in relation to the speaker
setup microphone so that "Score" becomes "10.0"
If the number does not become "10.0", put the
speaker in the position where the maximum value
is achieved.
• Do not move the Surround Left speaker,
upon which calibration is based, during the
adjustments.
Move the speakers back and forth about a
centimeter at a time in relation to the speaker
setup microphone so that "Score" becomes "10.0"
If the number does not become "10.0", put the
speaker in the position where the maximum value
is achieved.
• Do not move the Surround Right speaker,
upon which calibration is based, during the
adjustments.
MCACC Data Check
You can check the number of speaker channels connected and the content and values
you have set for each of the speaker settings. Depending on the item, you can check by
changing the MCACC memory or Channel with the cursors.
■ Speaker Setting
You can check the number of speaker channels connected and the large and small settings
you have set for the low range reproduction capabilities for each of the speakers.
■ Channel Level
You can check the output level settings for each of the speakers.
■ Speaker Distance
You can check the distance from each speaker to the listening position.
■ Standing Wave
You can check the settings of the standing wave control filter.
■ Acoustic Calibration EQ
You can check the calibration values for the frequency characteristics of each speaker that
were set in "Manual MCACC".
■ Group Delay
You can check the group delay of speakers before and after calibration.
> Basic Manual
Troubleshooting | Appendix