Table of Contents
Advertisement
Setting flow chart for KW2G main unit and Expansion unit (power measurement)
Mode 1...Mode for setting each parameter for power measurement
The mode with ★ is not displayed when it shift to expansion units.
The mode with ☆ is not displayed when the software version doesn't support it.
Monitor (Display when power on)
<MODE> continuous
Setting mode
(Mode 1)
<SET>
Phase/Wire system setting mode
SYST
<SET>
CT type setting mode
CT-T
<SET>
VT setting mode
VT
<SET>
Shift average frequency
setting mode
AVG
<SET>
Simple measuring setting mode ★
SIMP
Cutoff current setting mode
CUTA
<SET>
Current for time measurement 1 ☆
1.HM-A
<SET>
Current for time measurement 2 ☆
2.HM-A
<SET>
Select M (Main unit) before the settings.
When select
'5A'
When select
<SET>
other than '5A'
When select
'ON'
<SET>
When select
'OFF'
<SET>
(Mode 2) ★
(Mode 3) ★
<SET>
Primary side current of
CT setting mode
CT-1
<SET>
Simple voltage setting mode ★
S.VLT
<SET>
Simple PF setting mode ★
S.PF
<SET>
Unit for pulse output setting mode★
PL-P
When select
<SET>
'Values
Pulse output width setting ★
PL-W
<SET>
Electricity rate setting mode ★
RATE
<SET>
Conversion factor setting mode ★
CO2
<SET>
<SET>
Monitor
Press <MODE> to return Monitor.
25
KW2G Eco-POWER METER
(Mode 4) ★
<SET>
Refer to p.26.
When select
except 'Value'
the next page.
<SET>
Refer to
Advertisement
Table of Contents
