Ieee 1284 Menu - InfoPrint 6500 DBCS User Manual

IEEE 1284 Menu

The IEEE 1284 interface is configured using the following configuration
options.
IEEE 1284
(from page 84)
Buffer Size in Auto
Kbytes Trickle
64* Disable*
(1-256) Enable
Buffer Size in Kbytes
This parameter determines the size of the input buffer. Up to 256K are
available.
•
64 (the default)
•
1 – 256
Auto Trickle
Auto Trickle is used to prevent a host computer from timing out because the
parallel interface was busy for too long. When Auto Trickle is enabled and the
printer's buffers are almost full, the printer will begin to trickle data in (at the
rate set in the Trickle Time menu) until the buffers start to empty out.
* = Factory Default
Trickle
Time
1/4 sec*
1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
OFF
To cycle through the menus and its
options, press MENU then:
Scroll/
Micro
To enter a menu or select menu options,
press ENTER.
To return to a previous menu level,
press RETURN.
To exit the configuration menus
and return to READY, press START.
Serial Interface Menu
IEEE 1284 Menu
Scroll/
OR
Micro
89