Table 7. Terminating Resistor Configurations
Configuration
Factory Default
Alternate 1
Alternate 2
Removal And Installation
The procedure for removing and installing terminating resistors is provided in
your InfoPrint 6500 Line Matrix Printers: Maintenance Information Manual.
This is an involved maintenance procedure. To avoid damage to the
equipment, only a trained technician should perform this procedure.
Terminating Resistor Configurations
Pull-Up (RP1)
Pull-Down (RP2)
1K ohm
470 ohm
330 ohm
220 ohm
none
Important
1K ohm
127