Table of Contents
Advertisement
RS-232 And RS-422 Serial Interface Configuration
RS-232 And RS-422 Serial Interface Configuration
Your printer is configured as the factory to match the interface you specifed.
By using the operator panel, you may verify and change several interface
parameters to meet specific application requirements.
Refer to page 116 for RS-232 and RS-422 parameter descriptions and
information for selecting values for the following parameters:
RS-232 and RS-422:
•
Baud rate (data rate selected from the operator panel)
•
Data Bits (7 or 8 Bits)
•
Stop Bits (1 or 2 Bits)
•
Parity (None, Odd, Even, Mark, or Sense)
RS-232 only:
•
Data Terminal Ready logic
•
Request to Send logic
Some application programs require a unique configuration. If the printer is not
working properly in the configuration you selected, contact an InfoPrint
service representative.
One Char Enquiry
When enabled, a status byte is sent back to the host when the poll character
or the command SFCC enquiry is sent to the printer (serial interface only).
The poll character is received and the status byte is sent whether the printer is
online or offline. The SFCC enquiry will only be processed when the printer is
online.
Poll Character
This option is used when One Char Enquiry is enabled. Whenever the printer
receives this character, it sends aresponse to the host indicating the current
state of the printer. It may be configured from 0 through 255. The default
value is 0.
119
Advertisement
Table of Contents
