Using the Stapler
Stapling Options
Several stapling options are available in the Phaser 5550 printer driver:
■
■
■
■
To select a stapling option in a supported driver:
Operating System
Windows 2000 or later
Mac OS X (version 10.3
and higher) driver
Note:
Low Staples Behavior
When the printer detects a low quantity of staples, a 15 minute delay is started during which
three things can happen:
■
■
■
If no action is taken by the end of the 15 minutes, the print job will resume, run the staples out,
and continue to print without stapling.
Downloaded From ManualsPrinter.com Manuals
No Stapling: This is the default option. When selected, prints are not stapled.
1 Staple: Inserts one staple in each set of copies.
2 Staples: Inserts two staples in each set of copies.
Advanced Stapling: Provides options for controlling staple placement.
Steps
On the Output Options tab, select an option from the Stapling
drop-down list.
In the Print dialog box, select Finishing Options from the drop-down
list, and then select the stapling option.
You can use the control panel or CentreWare IS to set the default stapling option.
The print job can be resumed without staples.
The user can refill the staple cartridge, and then continue the print job.
The print job can be cancelled.
Phaser® 5550 Printer
4-50
Using the Stapler