Automatic Address Assignment - Xerox Phaser 5550 User Manual

Automatic Address Assignment

Addresses can be assigned automatically when a router is found that offers one or more
prefixes. Automatically assigned addresses are routeable. Each router-supplied prefix is
combined with the Interface ID to create an address. The use of router-supplied prefixes is
enabled by default.
To enable/disable automatic address assignment, use one of the following options:
■
■
Enabling/Disabling Automatic Address Assignment with the Control Panel
To set the Interface ID on the control panel:
1.
2.
3.
4.
5.
Enabling/Disabling Automatic Address Assignment with CentreWare IS
To set the Interface ID with CentreWare IS:
1.
2.
3.
4.
5.
6.
7.
Downloaded From ManualsPrinter.com Manuals
The printer's control panel
CentreWare IS
Select , and then press the OK button.
Printer Setup
Select
Connection Setup
Select Network Setup , and then press the OK button.
Select , and then press the OK button.
TCP/IPv6 Setup
Select , and then press the OK button to turn Auto Assign
Auto Assign
Launch your web browser.
Enter your printer's IP address in the browser's Address field.
Click Properties.
Select the Protocols folder on the left navigation panel, and then click TCP/IP.
Click the TCP/IP (v6) button.
Select/deselect Use router supplied prefixes.
Click the Save Changes button at the bottom of the page.
, and then press the OK button.
Phaser® 5550 Printer
3-28
IPv6
or .
On Off