MUTOH VJ-1304 Quick Reference page 94

5 Troubleshooting
No. Possible cause
6 Are you using folded, torn or rolled media?
(3) The wrong media size is set during initialization
No. Possible cause
1 Are you using the recommended media?
2 Is the media loaded at an angle?
3 When the media is set, does it curl upward?
4 Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
5 Are you using media that has been printed on
already?
(4) Media jams frequently occur
NOTE NOTE
• If media other than the recommended one is used, correct media feeding cannot be assured.
No. Possible cause
1 Are you using the recommended media?
2 Is the media used in an environment other than
the one specified?
3 Are you using the old media?
4 Are you using the folded or wrinkled media?
5 Does the media bend?
Remedy
Replace the media.
Remedy
Use the recommended media.
Set the media straight.
Straighten the media or set a new media.
Only use the printer in an environment that is
specified for use.
Use a new media.
Remedy
Use the recommended media.
Use the media in a dedicated environment.
Replace it with new media.
Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
5-16
VJ-1304 QUICK REFERENCE
Reference
"4.2.2 Cautions
on handling media" in
the Operation Manual
Reference
"4.2.1 Media
type" in the Operation
Manual
3.5.2 Setting roll
media
3.5.2 Setting roll
media
3.5.1 Loading
roll media
"4.2.1 Media
type" in the Operation
Manual
Reference
"4.2.1 Media
type" in the Operation
Manual
"4.2.2 Cautions
on handling media" in
the Operation Manual
"6.1.2 Replacing
roll media" in the
Operation Manual
"4.2.1 Media
type" in the Operation
Manual
"5 Panel setup
menu" in the
Operation Manual