MUTOH VJ-1304 Quick Reference page 93

VJ-1304 QUICK REFERENCE
No. Possible cause
1 Are you using the recommended media?
2 Is the loading position of the media correct?
3 Is the scroller set correctly?
4 Are there any foreign materials such as paper
attached to the pressurizing roller?
5 Is the printer being used in an environment
other than the one specified, such as in direct
sunlight?
6 Are you using folded, torn or rolled media?
7 Does the media bend?
(2) The media is crumpled during initialization
NOTE NOTE
• If the media is jammed or torn, remove it according to "5.2 When media is jammed".
No. Possible cause
1 Are you using the recommended media?
2 Is the loading position of the media correct?
3 Is the media loaded at an angle?
4 Are there any foreign materials such as paper
attached to the pressurizing roller?
5 Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
Remedy
Use the recommended media.
Set the media correctly.
Set the scroller correctly.
Clean the pressurizing roller.
Only use the printer in an environment that is
specified for use.
Replace the media.
Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
Remedy
Use the recommended media.
Set the media correctly.
Set the media straight.
Clean the pressurizing roller.
Only use the printer in an environment that is
specified for use.
5-15
5 Troubleshooting
Reference
"4.2.1 Media
type" in the Operation
Manual
3.5.2 Setting roll
media
3.5.1 Loading
roll media
4.2.2 Cleaning
the inside of the
printer
Installation
manual
"4.2.2 Cautions
on handling media" in
the Operation Manual
"4.2.1 Media
type" in the Operation
Manual
"5 Panel setup
menu" in the
Operation Manual
Reference
"4.2.1 Media
type" in the Operation
Manual
3.5.2 Setting roll
media
3.5.2 Setting roll
media
4.2.2 Cleaning
the inside of the
printer
Installation
manual