Installing The Software - Siemens S7-300 Operating Instructions Manual

Installing the software

Introduction
You assign parameters for the FM 352 using the
interface is designed for FM 352 and FM 452. A description of the
available in the
Requirements
Before starting to assign parameters for the FM 352 Electronic Cam Controller, note the
requirements in the readme.rtf file, in particular, the required version of STEP 7. The
readme.rtf file is available on the CD included in your shipment.
Installation
To install the configuration package:
1. Place the supplied CD in the CD drive of your programming device / PC.
2. Start the Setup.exe program.
3. Follow the operating instructions provided by the installation program.
Result
The components of the configuration package are installed in the following directories:
● SIEMENS\STEP7\S7LIBS\FMx52LIB: FBs, FCs, and UDTs
● SIEMENS\STEP7\S7FCAM: Parameter assignment interface, Readme, Online Help
● SIEMENS\STEP7\EXAMPLES\zEn19_01andzEn19_02: Examples for FM 452 and
● SIEMENS\STEP7\MANUAL: Getting Started, Manuals
Note
If, when installing STEP 7, you chose a directory other than SIEMENS\STEP7, this directory
will be entered.
Configuring and assigning parameters
For further information, refer to the chapter "Commissioning the FM 352 (Page 61)".
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
Online Help
FM 352
Parameter assignment interface.
.
6
This
Programming interface
is
37