Console Mast Arm Replacement - Matrix T7X-01 Service Manual

CHaPTer 9: ParT rePlaCemeNT GUide

9.14 CoNSole maST arm rePlaCemeNT

1) Turn off the power and disconnect the cord from the machine.
2) Remove the console as outlined in Section 9.13.
3) Take off the cup holder from the right side of the treadmill (Figure A).
4) Use a 6 mm Allen wrench to remove one screw and take off the plastic hand rail (Figure B).
5) Remove the 5 Phillips screws and remove the right side upper plastic cover (Figures C, D, & E).
6) Cut the wire ties and begin to unthread the console cable (Figures F & G).
7) Remove the screws holding the console frame to the mast arms with a 6 mm Allen wrench in the openings with arrows (Figure H).
8) Lift the frame from the mast arms and set it aside (Figure I).
9) Use a 6 mm Allen wrench to remove lower mast arm mounting screws (Figure J).
10) Pull the mast arm from the side of the machine (Figure K).
11) If replacing the right side mast arm, the console cable must be threaded through it.
fiGUre b
fiGUre a
fiGUre e
fiGUre C fiGUre d
68