CHaPTer 9: ParT rePlaCemeNT GUide
9.3 rUNNiNG deCk remoVal
1) Remove the front shroud as outlined in Section 9.1.
2) Remove the four running deck screws using a 5 mm Allen wrench (Figure A).
3) Remove the running deck from the running belt (Figures B & C).
4) Be careful not to pinch fingers during removal / installation of the running deck.
5) The running deck is waxed on both sides so opposite side surface may be usable.
6) New running deck surfaces must ALWAYS be matched to a new running belt.
fiGUre a
fiGUre b
fiGUre C
56