Specifications And Features - Lectrosonics SMV Series Instruction Manual

SMV Series

Specifications and Features

Operating frequencies:
Block 470 470.100 - 495.600
Block 19 486.400 - 511.900
Block 20 512.000 - 537.500
Block 21 537.600 - 563.100
Block 22 563.200 - 588.700
Block 23 588.800 - 607.900
614.100 - 614.300
(Frequency usage varies by country)
Frequency range:
Channel Spacing:
Frequency selection:
RF Power output:
Compatibility Modes (6)
Pilot tone:
Frequency stability:
Deviation:
Spurious radiation:
Equivalent input noise:
Input level:
If set for dynamic mic:
If set for electret lavaliere mic:
Line level input:
Input impedance:
Dynamic mic:
Electret lavaliere:
Line level:
Input limiter:
Bias voltages:
Gain control range:
Modulation indicators:
Controls:
The FCC requires that the following statements be
included in this manual for the SMV and SMQV:
For body worn operation, this transmitter models has
been tested and meets the FCC RF exposure guidelines
when used with the Lectrosonics accessories supplied or
designated for this product. Use of other accessories may
not ensure compliance with FCC RF exposure guidelines.
Contact Lectrosonics if you have any questions or need more
information about RF exposure using this product..
This device complies with FCC radiation exposure limits as
set forth for an uncontrolled environment. This device should
be installed and operated so that its antenna(s) are not co-
located or operating in conjunction with any other antenna or
transmitter.
24
Block 24 614.400 - 639.900
Block 25 640.000 - 665.500
Block 26 665.600 - 691.100
256 frequencies in 100 kHz steps
for one 25.5 MHz wide block
100 kHz or 25 kHz
Control panel mounted membrane switches
Switchable; 50, 100 or 250 mW
Digital Hybrid Wireless (400 Series),
®
200 Series, 100 Series, Mode 3 , Mode 6, IFB
25 to 32 kHz; 5 kHz deviation
(in 400 Series Mode)
± 0.002%
± 75 kHz max. (in 400 Series Mode)
60 dB below carrier
–125 dBV, A-weighted
0.5 mV to 50 mV before limiting.
Greater than 1 V with limiting.
1.7 uA to 170 uA before limiting.
Greater than 5000 uA (5 mA) with limiting.
17 mV to 1.7 V before limiting.
Greater than 50 V with limiting.
300 Ohms
Input is virtual ground with servo adjusted
constant current bias
2.7 k Ohms
DSP Controlled Soft limiter, 30 dB range
Fixed 5 V at up to 5 mA
Selectable 2 V or 4 V servo bias for any
electret lavaliere.
44 dB; panel mounted membrane switches
Dual bicolor LEDs indicate modulation of
–20, -10, 0, +10 dB referenced to
full modulation.
Control panel with LCD and four membrane
switches.
Low frequency roll-off:
+6
+3
0dB
-3
Line in
-6
-9
-12
Audio Frequency Response:
Signal to Noise Ratio (dB):
SmartNR
(overall system, 400 Series mode)
OFF
(Note: the dual envelope "soft"
NORMAL
limiter provides exceptionally
FULL
good handling of transients
using variable attack and release
time constants. The gradual onset of limiting in the design begins below full
modulation, which reduces the measured figure for SNR without limiting by 4.5 dB)
Total Harmonic Distortion:
Audio Input Jack:
Antenna: Flexible, unbreakable steel cable.
Batteries:
Battery Life: SMV 50 mW (1 AA):
SMV 100 mW (1 AA):
SMV 250 mW (1 AA):
SMQV 50 mW (2 AA):
SMQV 100 mW (2 AA):
SMQV 250 mW (2 AA):
Weight:
SMQV: 3.7 oz.. (105 grams) with lithium batteries
Overall Dimensions:
RM: 2.3 x 1.8 x 0.64 inches
(not including microphone/lanyard)
58 x 46 x 16 mm
(not including microphone/lanyard)
RM2: 2.125 x 1.25 x 1.125 inches
(not including microphone/lanyard)
54 x 32 x 29 mm
(not including microphone/lanyard)
Emission Designator: 180KF3E
Specifications subject to change without notice.
The FCC requires that the following statement be in-
cluded in this manual for the RM:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
This device complies with Industry Canada radiation exposure
limits as set forth for a controlled "professional" use only.
Adjustable from 35 to 150 Hz.
Mic in 35 Hz
Roll-off
Mic in 150 Hz
Roll-off
30 100 1kHz 10k
35 Hz to 20 kHz, +/-1 dB (The low frequency
roll-off is adjustable - see graph above)
No Limiting w/Limiting
103.5 108.0
107.0 111.5
108.5 113.0
0.2% typical (400 Series mode)
Switchcraft 5-pin locking (TA5F)
1.5 Volt AA lithium
Lithium
7.25 hrs
5.5 hrs
3 hrs
14.5 hrs
14 hrs
7.5 hrs
RM: 2.3 oz.. (65.8 grams) with lithium battery
SMV: 2.3 x 1.8 x 0.64 inches
(not including microphone/lanyard)
58 x 46 x 16 mm
(not including microphone/lanyard)
SMQV: 2.3 x 2.4 x 0.64 inches
(not including microphone)
58 x 60 x 16 mm
(not including microphone)
LECTROSONICS, INC.
20k