Design Of The Device; Operator Controls And Interfaces - Siemens SIMATIC IPC677D Operating Instructions Manual

Overview

1.2 Design of the device

1.2 Design of the device
1.2.1

Operator controls and interfaces

Device with PROFIBUS interface
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
14
PROFIBUS DP/MPI PROFIBUS DP/MPI interface (RS 485, isolated), 9-pin sub D socket
fieldbus
On/off switch You switch on the device with the on/off switch. This requires that the
BIOS setup entry "After Power Failure" is set to "Power On".
The on/off switch does not isolate the device from the power supply.
Position "ON", when the "-)" symbol is pressed inward on the device.
Position "OFF" is the factory state.
100-240 VAC Power supply connection
2 × Ethernet
•
•
4 × USB USB 3.0 high current, backward compatible with USB 2.0/1.1
COM1 Serial interface
DisplayPort DisplayPort connection for digital monitor
DVI-I DVI connector for CRT or LCD monitor with DVI port
PCI/PCIe expansion behind the cover
cards,
COM2/LPT and USB
on expansion card
(optional)
On/off button The on/off button has three functions:
•
•
•
Note: The BIOS setup entry "After Power Failure" has been set to
"Power On". This means the device is switched on with the on/off
switch. You then do not need to press the on/off button.
4 status LEDs Status display of the operating state
X1P1, left: RJ45 Ethernet port 1 (exclusive PCI interrupt) with
10/100/1000 Mbps, iAMT capable
X2P1, right: RJ45 Ethernet port 2 (shared PCI interrupt) with
10/100/1000 Mbps
Switch on the PC: Briefly press once
Shut down operating system and switch off PC: Briefly press once
Switch off PC without shutting down the operating system (hardware
reset): Press for more than 4 seconds.
Operating Instructions, 09/2014, A5E32995420-AC
SIMATIC IPC677D