Siemens SIMATIC IPC677D Operating Instructions Manual page 36

Mounting and connecting the device
3.2 Mounting the device
1.
2.
3.
4.
5.
See also
Preparing the mounting cutout (Page 29)
36
Working from the front, insert the device
into the mounting cut-out.
Insert the mounting clamp into the re-
cesses on the device. Make sure it is in
the correct position, see the section
"Mounting clips or mounting brackets,
position for IP65 (Page 33)".
Secure the mounting bracket by tighten-
ing the threaded pins. The maximum
permissible torque is 0.5 Nm.
Repeat steps 2 and 3 until all mounting
brackets are attached.
Check the fit of the mounting seal.
Operating Instructions, 09/2014, A5E32995420-AC
SIMATIC IPC677D