Connecting To The Srx550 Services Gateway From The J-Web Interface - Juniper SRX550 Hardware Manual

SRX550 Services Gateway Hardware Guide
Related
Documentation

Connecting to the SRX550 Services Gateway from the J-Web Interface

100
Table 29: Services Gateway Basic Connectivity Settings
Details (continued)
Element Description
Time zone You define the time zone for the
and system location where you plan to operate the
time services gateway by using a
designation that consists of the
following information for the location:
Name of the continent or ocean—for
example, America or Pacific
Name of the major city or other
geographic feature in the time
zone—for example, Boston or
Azores
It is recommended that you set the
system time before you begin
configuration.
SRX550 Services Gateway Basic Connectivity Overview on page 97
Connecting to the SRX550 Services Gateway from the J-Web Interface on page 100
Connecting to the SRX550 Services Gateway from the CLI Locally on page 103
Connecting to the SRX550 Services Gateway from the CLI Remotely on page 105
To use the J-Web setup wizard to configure the SRX550 Services Gateway, you must
connect through one of the built-in Ethernet management ports.
NOTE: To access the J-Web interface, your management device requires a
supported browser: either Microsoft Internet Explorer version 7.0 or Mozilla
Firefox version 3.0 (or later).
When the services gateway is powered on for the first time, the system looks for a DHCP
server. If it does not find one, it assigns an IP address within the
to any device connected to it.
To connect to the J-Web interface through the port labeled
the services gateway, see Figure 25 on page
Settings
A Network Time Protocol (NTP) server
provides accurate time across a
network. The device synchronizes the
system time with the NTP server and
periodically accesses the NTP server to
maintain the correct time.
The time zone and system time must be
accurate so that the device schedules
events and operations as expected.
NOTE: For Common Criteria
compliance, you must configure NTP to
provide accurate timestamps for system
log messages. For more information, see
Configuration Guides for Junos
the
OS Public Sector Certifications
192.168.1.0/24
(interface ge-0/0/1) on
0/1
101.
Copyright © 2015, Juniper Networks, Inc.
.
network