Installing The Mounting Hardware; Preparing The Srx550 Services Gateway For Rack-Mount Installation - Juniper SRX550 Hardware Manual

CHAPTER 14

Installing the Mounting Hardware

Preparing the SRX550 Services Gateway for Rack-Mount Installation

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Preparing the SRX550 Services Gateway for Rack-Mount Installation on page 69
Connecting the SRX550 Services Gateway to the Building Structure on page 70
You can mount an SRX550 Services Gateway on four-post (telco) racks, enclosed
cabinets, and open-frame racks. Center-mount racks are not supported.
Before mounting the SRX550 Services Gateway in a rack:
Verify that the site meets the requirements described in
for the SRX550 Services Gateway" on page
Verify that you have the following parts available in your rack-mounting kit for the
SRX550 Services Gateway:
Rack-mounting brackets
Eight mounting screws to attach the mounting brackets to the chassis of the services
gateway
Four mounting screws to attach the mounting brackets to the rack rail
Verify that the racks or cabinets meet the specific requirements described in
Services Gateway Rack Size and Strength Requirements" on page
Place the rack or cabinet in its permanent location, allowing adequate clearance for
airflow and maintenance, and secure it to the building structure. For more information,
see "SRX550 Services Gateway Cabinet Airflow Requirements" on page
Remove the gateway chassis from the shipping carton. For unpacking instructions, see
"Unpacking the SRX550 Services Gateway" on page
SRX550 Services Gateway Cabinet Size and Clearance Requirements on page 47
Installation Overview for the SRX550 Services Gateway on page 61
"Site Preparation Checklist
35.
43.
65.
"SRX550
48.
69