Powering Off The Srx550 Services Gateway - Juniper SRX550 Hardware Manual

Related
Documentation

Powering Off the SRX550 Services Gateway

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Connecting the SRX550 Services Gateway to the AC Power Source on page 89
Connecting the SRX550 Services Gateway to a DC Power Source on page 92
Grounding the SRX550 Services Gateway on page 78
Resetting the SRX550 Services Gateway on page 136
Powering Off the SRX550 Services Gateway on page 95
SRX550 Services Gateway Front Panel on page 14
To power off the services gateway, press the Power button on the front of the services
gateway and hold it for 10 seconds. The services gateway immediately shuts down.
NOTE: Graceful shutdown is not supported on the SRX550 Services Gateway.
To remove power completely from the services gateway, unplug the AC power cord or
DC power supply cable.
After powering off a power supply, wait at least 60 seconds before turning it back on.
After powering on a power supply, wait at least 10 seconds before turning it off.
If the system is completely powered off when you turn on the power supply, the services
gateway starts as the power supply completes its startup sequence. If the services
gateway finishes starting and you need to power off the system again, first issue the
CLI command.
request system halt
After a power supply is turned on, it can take up to 60 seconds for status indicators—such
as the POWER LED (on the front panel of the chassis) and the
display—to indicate that the power supply is functioning normally. Ignore error indicators
that appear during the first 60 seconds.
Grounding the SRX550 Services Gateway on page 78
Resetting the SRX550 Services Gateway on page 136
Powering On the SRX550 Services Gateway on page 94
SRX550 Services Gateway Front Panel on page 14
Chapter 18: Providing Power to the SRX550 Services Gateway
show chassis command
95