Table of Contents
Advertisement
34
www.aeg.com
12.4 Steam generation system
CAUTION!
Dry the steam generator
after each use. Remove the
water with the sponge.
Remove the limescale with
water and vinegar.
CAUTION!
Chemical de-scaling agents
can cause damage to the
enamel. Follow the
instructions of the
manufacturer.
1. To clean the water drawer and the
steam generator, put the water and
vinegar mixture (approximately 250
ml) through the water drawer into the
steam generator. Wait for
approximately 10 minutes.
2. Remove the water and vinegar with
the sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the
appliance dry fully.
12.5 Removing the oven door
Remove the door to clean the inner side
of the appliance more easily.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully release the clamping levers on
the hinges.
4
3
3. Hold the door on the two sides and
4. Pull the door away from the
5. Put the door with the outer side
12.6 Installing the oven door
1. Hold the door on the two sides at an
2. At the same time push the door
3. Lift the door up until you are at the
4. Fully lock the clamping levers on the
5. Close the door of the appliance.
12.7 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
1. Deactivate the appliance.
2
2. Remove the fuses from the fuse box
The side lamp
1. Remove the left shelf support to get
close it approximately 3/4 of the way.
appliance.
down on a soft cloth on a stable
surface. This is to prevent scratches.
WARNING!
Be careful when you install
the door. The door is heavy.
angle of approximately 60°.
3
4
60º
4
hinges as far as they can go into the
two recesses at the bottom of the
appliance on the left and the right.
point of resistance and then open it
as far as possible.
hinges.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
or deactivate the circuit breaker.
access to the lamp.
5
Advertisement
Table of Contents
