Installation - AEG 17166GT-MN User Manual

Problem
The lamp does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance makes noises.
The display shows "12.00".
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

13. INSTALLATION

WARNING!
Refer to Safety chapters.
13.1 Technical data
Dimensions
Height
Width
Depth
Possible cause
The lamp is defective.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
There was a power cut.
894 - 912 mm
595 mm
600 mm
Remedy
Replace the lamp.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Some metal parts of the ap-
pliance expand and contract
when they heat up or cool
down. The noises are nor-
mal.
Reset the clock.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
13.2 Location of the appliance
You can install your freestanding
appliance with cabinets on one or two
sides and in the corner.
For the minimal distances of fitting check
the table.
ENGLISH 25