4
PROCEDURES AND SETTINGS BEFORE
OPERATION
4.2
Procedures before Operation
The following flowchart shows the procedures for operating the QD63P6.
Module mounting
Mount the QD63P6 to the specified slot.
Wiring
Wire external devices to the QD63P6.
Intelligent function module switch setting
Set the switches with GX Developer
(refer to Section 4.5).
Use GX Configurator-CT?
No
Make the initial setting?
Initial setting
Create a sequence program for writing
initial values with the FROM/TO
instruction.
Programming
Create and a program for counter
processing with the FROM/TO instruction
and check it.
Start
Yes
No
Yes
Operation
Figure 4.1 Procedures before operation
No
Make the initial setting?
Yes
Initial setting
Make initial settings with
GX Configurator-CT (refer to Section 6.4).
No
Make the auto refresh setting?
Yes
Auto refresh setting
Make the auto refresh setting with
GX Configurator-CT (refer to Section 6.5).
Programming
Create and a program for counter
processing without the FROM/TO
instruction and check it.
4.2 Procedures before Operation
1
2
3
4
5
6
7
8
4
- 2