Table of Contents
Advertisement
7
PROGRAMMING
(3) Program example
An interrupt must be enabled using the IMASK instruction before using an interrupt
pointer.
<Enabling interrupt of I50>
<Interrupt program>
POINT
7.3 Program Example when the Coincidence Detection Interrupt Function is Used
QD63P6 program
Interrupt program
• When the above described program is executed, only I50 interrupt
program is execution-enabled and other interrupt programs are
execution-disabled.
When executing interrupt programs other than I50, set the corresponding
bit for interrupt program to be executed to 1 (enabled).
• For details of the IMASK instruction, refer to QCPU (Q Mode)/QnACPU
Programming Manual (Common Instructions).
1
2
3
4
5
6
7
8
7
- 14
Advertisement
Table of Contents
