Main Menu; Monitoring - Ingecon Sun 250 M220 Indoor Installation Manual

Ingeteam

8.3. Main menu

The main menu contains the following submenus:
• Monitoring. This displays the main internal parameters
and variables that indicate the operation status of the unit.
• Reasons for shutdown. This option shows the reasons
why the inverter was shut down the last five times.
• Settings. This menu displays all the settings that
affect the inverter.
• Inverter data. This option offers inverter-specific data.

8.4. Monitoring

This menu is accessed by pressing the
MOnITORIng menu.
See below for the structure and interpretation of the variables in this menu:
Screen 1
Pac Power inverter is delivering into the grid, in kW.
Pdc
Power supplied by solar panels, in kW.
etot Total energy in kWh delivered by the inverter to the grid from the date it was manufactured. Recording
the serial number of the equipment marks the start of this power log.
Pare: Total energy in kWh delivered by the inverter to the grid since the last time the counter was reset.
Screen 2
Vdc Voltage supplied by solar panels to the inverter.
Vac1
Inverter output voltage in phase one of the grid.
Vac2 Inverter output voltage in phase two of the grid.
Vac3 Inverter output voltage in phase three of the grid.
Screen 3
Idc current supplied by solar panels to the inverter.
Iac1 Inverter output current in phase one.
Iac2 Inverter output current in phase two.
Iac3 Inverter output current in phase three.
Screen 4
Frec1 Phase one frequency.
Frec2
Phase two frequency.
Frec3 Phase three frequency.
cos.Phi cosine of Phi. cosine of the phase shift angle between grid voltage and current supplied by the inverter.
Screen 5
Rpv Impedance of the entire PV array to ground.
70
17:54 17:54
key in the
17:54 17:54
Monitoring Monitoring
Installation manual
03/08/12 03/08/12
03/08/12 03/08/12
AAV2000IKI01