Personal Protection Equipment (Ppe) - Ingecon Sun 250 M220 Indoor Installation Manual

Ingeteam
5 gOLDen RuLeS
1. Disconnect
Switching on the possible voltage sources. Bear in mind that any capacitors or other elements powered
from uninterruptible power supplies (uPS) are still live.
2. Prevent any possible feedback.
The switching devices used to switch off the equipment must be protected against any possible
disconnection.
3. check there is no voltage.
check that there is no voltage in all the active elements of the electrical system or as close as possible
to the work area.
4. ground and short circuit.
In the low voltage installations that by induction or for other reasons may be accidentally live. And
always in high voltage installations.
5. Rope off and mark the work area.

4.4.4. Personal Protection equipment (PPe)

Inspection
The use of safety footwear to standard EN 345-1:1992 is mandatory and work clothing should be cotton and be free
of conductor/metallic elements.
control
The use of helmets compliant with standard EN 397:1995 and safety footwear compliant with standard EN 345-1:1992
is mandatory. The use of standard safety gloves is also mandatory for voltage-free tasks.
It is also mandatory to use dielectric gloves meeting standard EN-60903-1992 and protective face mask against
electric shock for voltage testing tasks and opening or closing automatic switches under load (IP2x).
Handling
The use of helmets compliant with standard EN 397:1995 and safety footwear compliant with standard EN 345-1:1992
is mandatory.
It is also mandatory to use dielectric gloves meeting standard EN-60903-1992 and protective face mask against
electric shock for voltage testing tasks and opening or closing automatic switches under load (IP2x).
30
Installation manual
AAV2000IKI01