Conservation; Waste Handling - Ingecon Sun 250 M220 Indoor Installation Manual

Installation manual
• cover the unit with a breathable protective material in order to prevent condensation due to ambient humidity.
• units in storage must not be subjected to climate conditions other than those indicated in Section "2.2.
Environmental characteristics".
• It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
• Do not store the unit outdoors.

3.6. conservation

In order to permit correct conservation of the units, they must not be removed from their original packaging until it
is time to install them.
In case of prolonged storage, the use of dry places avoiding, as far as possible, sharp changes in temperature is
recommended.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation. Ingeteam accepts no liability in the case of failing to observe this condition.

3.7. Waste handling

During the various processes for installation, start-up and maintenance, waste is generated which must be handled
appropriately according to the regulations in the corresponding country.
At the end of the unit's life, the waste must be processed by an authorised waste management company.
Ingeteam, in accordance with its policy of respect for the environment, will inform the authorised manager, via this
Section, of the location of components to be decontaminated.
The elements within the unit that must be handled individually are:
1. Liquid crystal displays
2. electrolytic condensers or condensers containing PcB.
3. Batteries and accumulators
4. Printed circuit cards.
Their location is shown in the following images.
AAV2000IKI01
1 4 2
2 4
Ingeteam
25