Table of Contents
Advertisement
SUPERSERVER 2028TP-HTR/HC0R/HC1R-SIOM USER'S MANUAL
Figure 6-1. Front and Rear Chassis Views
Control Panel
Control Panel
SATA Drives (24)
LAN Ports
Low-Profile PCI-E Slot
IPMI LAN Port
USB Ports
UID Switch/LED
Note: the figure above shows a server with AOC-MTG-i4S SIOM cards installed.
See Figure 6-18 for a map of the hard drives.
6-2
Control Panel
The control panel is located on the front of the chassis. The LEDs inform you of
system status.
See Chapter 3 for details on the LEDs and the control panel buttons.
Control Panel
Control Panel
Power Supplies
VGA Port
6-2
6-3
Chassis Cover
Before operating the SC217HQ+ chassis for the first time, it is important to remove
the protective film covering the top of the chassis, in order to allow for proper
ventilation and cooling.
Removing the Chassis Cover and Protective Film (Figure 6-2)
1. Uplug the AC power cord from any external power source.
2. Remove the two screws which secure the top cover onto the chassis as
shown above.
3. Lift the top cover up and off the chassis.
4. Peel off the protective film covering the top cover and the top of the chassis
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
6. Replace the chassis cover and reconnect the AC power cord.
Figure 6-2. Removing the Chassis Cover
1
2
Remove two
1
screws
4
Caution: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and prevent
overheating.
Chapter 6: Advanced Chassis Setup
1
3
1
5
Check Ventilation
Openings
6-3
Advertisement
Table of Contents
