Table of Contents
Advertisement
SUPERSERVER 2028TP-HTR/HC0R/HC1R-SIOM USER'S MANUAL
Installing Expansion Cards (Figure 6-14)
1. Disconnect the chassis from any power source, lay the chassis on a flat
surface, and open the chassis cover.
2. Pull out the serverboard node drawer from the chassis.
3. Pull open the expansion card PCI slot clip in the rear of the serverboard node
drawer.
4. Remove the PCI PCI slot shield.
5. Place the expansion card into the serverboard node drawer.
6. Slide the expansion card into the rear riser card PCI slot and fit the expansion
card bracket with the opening in the rear of the serverboard node drawer.
7. Close the expansion card PCI slot clip.
8. Close the cover, reconnect the power supply and power-up the chassis.
Figure 6-14. Installing the Expansion Card
Expansion Cards
Riser Cards
6-16
6-10 Drive Bay Installation/Removal
Accessing the Drive Bays
SATA Drives: You do not need to access the inside of the chassis or remove power
to replace or swap SAS/SATA drives. Proceed to the next step for instructions. You
must use standard 1" high, SATA drives in the system.
Note: Refer to the following FTP site for setup guidelines: <ftp://ftp.supermicro.com/
driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's web site for
additional inmformation < http://www.supermicro.com/support/manuals/>.
The SC217HQ+ chassis contains four individual serverboards in separate node
drawers. Each serverboard node controls a set of six hard drives. Note that if a
serverboard node drawer is pulled out of the chassis, the hard drives associated
with that node will power down as well.
Serverboard Drawer Locations in the Chassis
Serverboard B
Controls HDDs B1, B2, B3, B4, B5 and B6
Serverboard A
Controls HDDs A1, A2, A3, A4, A5 and A6
Figure 6-15. Hard Drives and the Corresponding Serverboards
1
A
1
B
1
C
1
D
Chapter 6: Advanced Chassis Setup
Serverboard D
Controls HDDs D1, D2, D3, D4, D5 and D6
Serverboard C
Controls HDDs C1, C2, C3, C4, C5 and C6
6-17
Advertisement
Table of Contents
