Prepare Data Base; Initial Data Application; Basic Engine Data; Crank‐ And Camshaft Wheel - Bosch MS 6 Manual

Caution
4.1.1
4.1.2
Bosch Motorsport
4

Prepare Data Base

Using RaceCon, the data base is already generated and the modification may
start immediately. For information, please see RaceCon manual.
ModasSport uses the two MS 6 programs MS6a_xxxx_yyyy_data.s19 and
MS6a_xxxx_yyyy_ms_a2l for work folder generation.
For help, please follow the Modas Sport manual instructions.
4.1

Initial Data Application

The following chapter deals only with the main parameters which should be
checked before a first engine startup. Several functions are recommended to be
switched off, many software labels will not be explained in detail. To work on
these functions and labels after the first startup, please refer the full‐scope func‐
tion description. The offline data application guide shall help to get the engine
started the first time without problems.
Wrong engine setup data may lead to serious engine damages.

Basic Engine Data

The MS 6 system can be used for engines up to 12 cylinders. Please ensure that
the correct software variant is loaded in your ECU. Define the engine parameters
like number of cylinders, firing order, injection system and cam‐ and crankshaft
designs in relation to TDC.
Crank‐ and Camshaft Wheel
The system initially supports wheels with 60‐2 teeth. Other configurations in the
limits between 30- and 60 teeth may be possible to configure also. Please refer
also to the chapter Ignition Trigger Wheel
Main Data Labels to configure for crank- and camshaft wheel
CRANK_TOOTH_CNT
CWINTF_CRANK
CRANK_GAP_TOOTH_CNT
CAM_MODE
CAM_TOOTH_CNTx
CAM_POS_EDGESx
[}
Number of teeth of the flywheel (in‐
cluding the missing teeth) (limited to
30-60 teeth)
Selection of used crankshaft sensor
type (Hall or inductive type)
Number of missing teeth on the fly‐
wheel
Camshaft position detection mode
Number of teeth on the camshaft
Position [°CRK] of positive camshaft
edges
ECU MS 6
Prepare Data Base | 4
20].
29 / 78