Drive Belt Replacement - Matrix C7X - 03 Service Manual

9.15 DRIVE BELT REPLACEMENT

1) Turn off power and disconnect the cord from the machine.
2) Remove the drive set as outlined in Section 9.10.
3) Loosen the belt tension nut (Figure A) and screw (Figure B) until there is enough slack in the drive belt to remove it (Figure C).
4) Use a straight edge to make sure that the pulley and encoder pulley are in a straight line (Figure D).
5) Reverse Steps 1-4 to install a new drive belt. NOTE: Torque the screw removed in Step 3 to 60 N-m.
6) Test the Climb Mill for function as outlined in Section 9.20.
68
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE A
FIGURE C
FIGURE B
FIGURE D