4.14 Drive Axle Replacement - Matrix A30 Service Manual

4.14 Drive Axle Replacement

NOTE: A special tool from Matrix
at 866-693-4863 ext .2
off
1. Turn the power and
2. Remove the covers from the machine as
3. Loosen tension bolts nuts to remove drive belt .
4. On the left side of the frame, remove the retainer clip that holds the drive axle bearings in the frame (Figure A).
5. Use a hammer to hit the screw until the drive axle assembly is loose in the
6. Install the tool into the hole in the frame and use a rubber or wooden
can be removed from the frame (Figure C & D).
7. The drive axle should have come with an iron plate installed (Figure E).
Assemble the Matrix tool as shown in Figure F.
is needed to correctly replace a
disconnect the cord from the
outlined
I
FIGURE A
FIGURE C
FIGURE E
drive axle. Order part#
machine.
in section 4.11.
frame,
mallet
1000368807 from Matrix CTS
and remove it (Figure B).
FIGURE 8
to hit the end of the tool until the bearing
FIGURED
Kits number: 1000368807
FIGURE F
37