Ecb Belt Replacement - Matrix C7X - 03 Service Manual

9.14 ECB BELT REPLACEMENT

1) Turn off power and disconnect the cord from the machine.
2) Rotate the 2 plastic clips counter-clockwise to remove the Matrix logoed cover (Figures A & B).
FIGURE A
3) Turn the brake to the left to lock the stairs.
4) Disconnect the brake and both fan wire connections (Figure C).
5) Remove the 4 screws holding the brake and fan plate to the drive set (Figure D) and remove the assembly.
FIGURE C
6) Remove the old ECB belt.
7) Install a new ECB belt. NOTE: There is a belt installation tool available to assist with installing the Flexonic belt (Figure E - part # 0000093787).
After installation, rotate the belt at least 3 full revolutions to insure the belt is centered.
8) Reverse Steps 1-5 to re-assemble the unit.
9) Test the Climb Mill for function as outlined in Section 9.20.
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE E
FIGURE B
FIGURE D
67