Table of Contents
Advertisement
Maintenance and cleaning
Before replacing components
Please make sure to cut off the power and unplug the power cord from the power outlet when you
make
maintenance or replacement of components about your projector.
Maintenance
Clean casing of your projector
● Gently wipe the casing with clean and soft cloth.
● If you need to clean the dust, select the dry cloth which soaked
with water and wrung dry to wipe your projector.
● Do not use gasoline, thinner, or rubbing alcohol, other
solvents, kitchen detergent or chemical cloth which may
change or scratch the casing surface.
● Place your projector in proper container after use to protect it
from dirt and dust and being scratched.
Projection window
● Gently wipe the projection window with clean and soft cloth.
● Do not use a rough or humid, greasy or dusty cloth.
● Do not wipe the projection window forcefully as it is fragile.
Note:
Projection window is fragile. Avoid unnecessary
collision or excessive force when wiping it ,otherwise
it may scratch the surface. Please take care!
Note on LCD Drive board
Please do not use your projector at place of dust and
smoke. This may affects image quality. Using your
projector in place of dust and smoke may lead to piling
dusts on lens, LCD panel, and lens components within
it. In case like this, please
LCD Driver board (Look at image)
alcohol and cotton swab.
use the air gun to blow the
and do not wipe with
-10-
Advertisement
Table of Contents
