Table 1-1. Mvme3100 Features Summary - Motorola MVME3100 Programmer's Manual

Table 1-1. MVME3100 Features Summary

Feature
Processor/Host
Controller/Memory
Controller
System Memory
I2C Interface
Flash
PCI Interface
I/O
Description
– Single 667/833 MHz MPC8540 PowerQUICC III™ integrated
processor (e500 core)
– Integrated 256KB L2 cache/SRAM
– Integrated four-channel DMA controller
– Integrated PCI/PCI-X controller
– Two integrated 10/100/1000 Ethernet controllers
– Integrated 10/100 Ethernet controller
– Integrated dual UART
– Integrated I2C controller
– Integrated programmable interrupt controller
– Integrated local bus controller
– Integrated DDR SDRAM controller
– One SODIMM socket
– Up to DDR333, ECC
– 256MB or 512MB SODIMM
– One 8KB VPD serial EEPROM
– Two 64KB user configuration serial EEPROMs
– One real-time clock (RTC) with removable battery
– One temperature sensor
– Interface to SPD(s) on SODIMM and P2 for RTM VPD
– 32MB to 256MB soldered Flash with two alternate 1MB boot
sectors selectable via a hardware switch
– Hardware switch or software bit write protection for entire logical
bank
Bus A:
– 66 MHz PCI-X (PCI-X 1.0b compliant)
– One TSi148 VMEbus controller
– One serial ATA (sATA) controller
– Two PCI6520 PCI-X-to-PCI-X bridges (primary side)
Bus B:
– 33/66/100 MHz PCI/PCI-X (PCI 2.2 and PCI-X 1.0b compliant)
– Two +3.3V/5V selectable VIO, 64-bit, single-wide PMC sites or
one double-wide PMC site (PrPMC ANSI/VITA 32-2003 and PCI-X
Auxiliary ANSI/VITA 39-2003 compliant)
– One PCI6520 PCI-X-to-PCI-X bridge (secondary side)
Bus C (-1263 version):
– 33 MHz PCI (PCI 2.2 compliant)
– One USB 2.0 controller
– One PCI expansion connector for interface to PMCspan
– One PCI6520 PCI-X-to-PCI-X bridge (secondary side)
– One front panel RJ45 connector with integrated LEDs for front I/O:
one serial channel
– One front panel RJ45 connector with integrated LEDs for front I/O:
one 10/100/1000 Ethernet channel
– One front panel external sATA data connector for front I/O: one
sATA channel
– One front panel USB Type A upright receptacle for front I/O: one
USB 2.0 channel (-1263 version)
– PMC site 1 front I/O and rear P2 I/O
– PMC site 2 front I/O
MVME3100 Programmer's Guide (V3100A/PG1)
Chapter 1 Board Description and Memory Maps
3