Dispenser Heater - Viking VCSB542 Service Manual

Service Diagnostics and Procedures

Dispenser Heater

The dispenser has a heater foamed into the door
to be used in case of moisture/sweating in the
dispenser assembly. The heater does not leave the
factory hooked up and can be connected if needed.
Dispenser Heater
© 2010 Viking Preferred Service
Dispenser Heater
(rear view)
To connect the dispenser heater:
1. Remove escutcheon (follow bezel dispenser
disassembly procedure).
2. Remove upper dispenser (refer to upper
dispenser disassembly procedure).
3. Locate wires with female ends for the heater in
the upper right hand corner.
Female Connectors
4. Locate wires with male ends.
5. Connect Red to Orange and White to Orange
or Red to Yellow and White to Yellow.
The dispenser heater has two heater loops and
should one open the alternate loop could be
connected. The heater measure 6800
Orange and Yellow – Yellow.
6. Reverse procedure to reinstall.
Male Connectors
Orange –
Ω
75