Table of Contents
Advertisement
Custom Panel General Information
• Panel thickness must not exceed 1"
Custom finishing options
• All installations must allow for the
refrigerator ad freezer door to open a
• A 1/4" wood filler or insulation filler must
minimum of 90˚.
• For side wall or corner installation, allow
for a standard 3" (7.6 cm) cabinet filler to
assure door(s) open 90˚.
ote: If a custom handle is used a wider
filler may be necessary.
Ice and Water Dispenser Bezel Removal (if required)
1
Remove packaging material surrounding bezel.
3
Remove spill tray form lower part of bezel
exposing two screws.
44
(2.5 cm) on hinge side. Thicker panels will
interfere with door swing and clearance.
be used between the door and 3/4" wood
panel to prevent condensation from
forming.
2
Grasping the sliding lever, pull away from bezel.
4
Remove screws.
5
Remove two additional screws under top
section of bezel.
7
Grasping the bezel on both sides, pull away from
Store bezel and spill tray in safe and secure place until
the door cavity.
ote: Bezel needs to be pulled from the bottom
first and then pull slightly downward to clear
the water dispensing tube.
For re-installation steps see pages 48-49.
45
6
Remove mounting support.
3 8
installation.
Advertisement
Table of Contents
