Ice Dispenser Module Assembly - Viking VCSB542 Service Manual

Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Ice Dispenser Module Assembly

When the ice dispenser Ice Door switch is activated,
120 volts is sent to the relay coil and the Ice Door
motor is energized. After the switch is deactivated,
the holding relay will keep the Ice Door open for
an additional 8 seconds to allow any remaining ice
cubes in the chute to dispense.
Ice Door
1. Remove cavity cover (follow cavity cover
disassembly procedure).
2 Remove screws to remove Ice Module
Assembly.
© 2010 Viking Preferred Service
Ice Door Motor
Holding Relay
WARNING
3. Replace ice dispenser assembly if necessary.
Ice Dispenser Assembly
4. Reverse procedure to reinstall.
72