Change An Existing Measuring Program; Print A Measuring Program - Mahr Digimar 817 CLM Operating Instructions Manual

7.4 Change an existing measuring
program
Changes to a measuring program are often necessary,
due to perhaps a change in a technical drawing
(different tolerance, nominal dimension...) or there has
been a review of the teach-in program. An existing
measuring program can be used as a basis for further
programs with similar parts.
Select the measuring program and change or add
improvements in the appropriate menu.
Procedure is the same as „Create a new measuring
program".
7.5

Print a measuring program

The complete program is printed out together with
the program head. The adjustment of the printer is
detailed in section „6.13 Data and printer" and „5.3
Printing measured values".
Procedure is the same as „Create a new measuring
program".
Mahr GmbH • Digimar 817 CLM
1. <-_______
2. Learn programming (teach - in)
3. Create new program
4. Change existing program
5. Print out current program
6. UCL / LCL computation (measured values)
7. UCL / LCL computation (tolerances)
Load program
8. Menu program file management
PRG1 09:57
9. Menu data file management
TEST1 09:59
10.Program STARTStart.
TEST5 10:18
Bytes free : 63001
1. <-_______
2. Learn programming (teach - in)
3. Create new program
4. Change existing program
5. Print out current program
6. UCL / LCL computation (measured values)
7. UCL / LCL computation (tolerances)
Load program
8. Menu program file management
PRG1 09:57
9. Menu data file management
TEST1 09:59
10.Program STARTStart.
TEST5 10:18
Bytes free : 60457
04/Sep/06 755
04/Sep/06 1175
04/Sep/06 587
04/Sep/06 755
04/Sep/06 1175
04/Sep/06 587
105