Hilti SID 14-A Original Operating Instructions page 6

1 Information about the documentation
1.1 Conventions
1.1.1 Warning signs
The following warning signs are used:
General warning
1.1.2 Symbols
The following symbols are used:
Read the operating instructions before use.
Instructions for use and other useful information
Rated speed under no load
Revolutions per minute
Direct current (DC)
1.1.3 Typographic emphasis
The following typographic features are used to emphasize important pas-
sages in the technical documentation about your impact screwdriver/wrench:
1 These numbers refer to the corresponding illustrations.
1.2 Operating instructions
▶ It is essential that the operating instructions are read before initial
operation.
▶ Always keep these operating instructions together with the tool.
▶ Ensure that the operating instructions are with the tool when it is
given to other persons.
Changes and errors excepted.
1.3 Product information
The type designation can be found on the type identification plate at the
base of the tool and the serial number on the side of the casing.
▶ Make a note of this data in the following table and always refer to it when
making an enquiry to your Hilti representative or Hilti Service Center.
Product information
Type:
Generation:
Serial no.:
Printed: 16.06.2015 | Doc-Nr: PUB / 5070695 / 000 / 03
01
1