Hilti SID 14-A Original Operating Instructions page 16

WARNING
Electrical hazards! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals
and the contacts in the impact screwdriver are free from foreign
objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others.
Check that the battery is securely seated in the power tool.
▶ Fit the battery and make sure that it is heard to engage.
5.2 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others.
Check that the belt hook is fitted securely before beginning work.
Note
The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
▶ Fit the belt hook.
5.3 Fitting an accessory tool
SID 14­A
SID 18­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.4 Removing the accessory tool
SID 14­A
SID 18­A
Printed: 16.06.2015 | Doc-Nr: PUB / 5070695 / 000 / 03
3
4
5
11