Extron electronics DXP HD 4K Series Setup Manual page 16

Terminate the Ethernet cable as required:
•
•
Default Ethernet settings:
•
•
•
G Analog audio outputs — Connect powered speakers, an
amplifier, or other audio output device to these 5-pole 3.5 mm
captive screw connectors for 2-ch stereo analog audio output.
These connectors can de-embed 2-ch LPCM audio that was
routed from any DXP HDMI input and convert it to a stereo
analog signal.
Sleeves
Figure 7.
The DXP 168 and 1616 have four analog audio output
connectors while the DXP 44, 84, and 88 have two.
ATTENTION:
H S/PDIF outputs (Sony/Philips Digital Interface Format) — Use
75 ohm digital audio cables to connect audio signal
processors (such as the Extron SSP 7.1 Surround Sound
Processor) or other compatible devices to these female
RCA connectors. The connected processor then converts
digital signals from these ports to analog for encoded standard
definition bitstream audio for Dolby or DTS multi-channel
surround sound.
10 DXP HD 4K Series • Setup
Network connection — Wire as a patch (straight-through)
cable.
Computer or control system connection — Wire as a
crossover cable.
IP address: 192.168.254.254
Subnet mask: 255.255.0.0
Gateway: 0.0.0.0
Tip
Ring
Tip
Ring
Balanced Audio Output
Wiring the Captive Screw Audio Output
Connectors
• For unbalanced audio output, connect the sleeves to
the ground contact. DO NOT connect the sleeves to the
negative (-) contacts.
• Pour l'audio asymétrique, connectez les manchons au
contact au sol. Ne PAS connecter les manchons aux
contacts négatifs (–).
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
Do not tin the wires!
S/PDIF