Ethernet connection indicators — The Link and
Act LEDs indicate the status of the Ethernet
connection.
•
•
Ethernet links use Category (CAT) 3, 5e, or 6 unshielded twisted
pair (UTP) or shielded twisted pair (STP) cables, terminated
with RJ-45 connectors. Ethernet cables are limited to 328 feet
(100 m).
NOTES:
Pins:
1 2 3 4 5 6 7 8
Pin
Wire Color
1
White-green
2
Green
3
White-orange
4
Blue
5
White-blue
6
Orange
7
White-brown
Insert Twisted
8
Brown
Pair Wires
RJ-45
Connector
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
Figure 6.
The cable you use depends on your network speed. The
switcher supports both 10 Mbps (10Base-T — Ethernet) and
100 Mbps (100Base-T — Fast Ethernet), half-duplex and
full-duplex Ethernet connections.
•
•
Link — Indicates that the switcher is properly
connected to an Ethernet LAN. This green LED
should light steadily.
Act (Activity) — Indicates transmission of data
on the RJ-45 connector. This amber LED should
flicker as the switcher communicates.
•
Do not use standard telephone cables. Telephone cables
do not support Ethernet or Fast Ethernet.
•
Do not stretch or bend the cables because this can
cause transmission errors.
Crossover Cable
End 1
End 2
Wire Color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
T568A
T568B
RJ-45 Connector and Pinout Tables
10Base-T Ethernet requires CAT 3 or higher UTP or STP
cables.
Fast Ethernet requires CAT 5e or higher UTP or STP cables.
Straight-through Cable
End 1
Pin
Wire Color
Wire Color
1
White-orange
White-orange
2
Orange
Orange
3
White-green
White-green
4
Blue
Blue
5
White-blue
White-blue
6
Green
Green
7
White-brown
White-brown
8
Brown
Brown
T568B
A cable that is wired the same at both ends
is called a "straight-through" cable, because
no pin or pair assignments are swapped.
DXP HD 4K Series • Setup
DXP 1616
Series
LAN
DXP 88 Series
End 2
T568B
9