Pro-Form 480 SpaceSaver User Manual page 8

5. Tip: Avoid pinching the Wire Harness (64).
Attach the Upright (10) to the Frame (1) with
four M8 x 19mm Patch Screws (86) and four
M8 Split Washers (97).
6. Identify the Right Pulse Bar (39), which is
marked with a "Right" sticker. Orient the Right
Pulse Bar so that the hexagonal holes are in
the indicated location.
Have another person hold the Right Pulse Bar
(39) near the Upright (10).
See the inset drawing. Locate the wire tie in
the Upright. Tie the lower end of the wire tie to
the right Pulse Wire (63). Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Tip: Avoid pinching the wires. Slide the Right
Pulse Bar (39) onto the right side of the Upright
(10). Attach the Right Pulse Bar with two M8 x
36mm Button Bolts (77) and two M8 Locknuts
(94). Make sure that the Locknuts are in the
hexagonal holes.
Repeat this step for the Left Pulse Bar (19).
5
64
86
97
97
1
Avoid pinching the
Wire Harness (64)
6
64
19
10
Wire Tie
63
8
10
97
86
97
Wire Tie
77
63
39
94
Hexagonal
Holes
Avoid pinching
the wires