Telnet Command: Ha Set - Draytek VIGOR2925 SERIES User Manual

T e l n e t C o m m
T e l n e t C o m m
This command can be used to configure HA settings for Vigor routers.
S y n t a x
S y n t a x
ha set [-<command> <parameter>| ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-e <1/0>
-l <1/0>
-M <1/0>
-v <1-255>
-R
-p <1-30>
-k <key>
-u <1/0>
-m <interface>
-s
-y
-c <1/0>
-I -[M|H|D] <interval>
Vigor2925 Series User's Guide
a n d : h a s e t
a n d : h a s e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several parameters in one
line.
1: Enable the function of High Availability (HA).
0: Disable the function of High Availability (HA).
1: Enable the function of recording the operation record of
HA in Syslog.
0: Disable the function of recording the operation record of
HA in Syslog.
Specify the Redundancy Method for HA.
1: Active-Standby
0: Hot-Standby
Specify the group ID (VHID)
1- 255: Setting range.
Set HA settings to Factory Default.
Specify the Priority ID.
1-30: Setting range.
Specify the Authentication Key.
Key: Max. 31 Characters.
Enable or disable the function of Update DDNS.
1: Enable. When a router changes HA status to primary, it
will update DDNS automatically.
0: Disable.
Specify the management interface.
Interface: LAN1 ~ LAN5, DMZ.
It means to get the newest status of other router (except the
local router).
It means sync local config to other router. Primary can
executes this command. Secondary can not execute this
commad.
Enable or disable the function of Config Sync.
1: Enable.
0: Disable.
Set the Config Sync Interval for HA. Minimum interval is 15
minutes.
-M: Minute. Setting range is 0/15/30/45. (e.g., ha set -I -M
30)
-H: Hour. Setting range is from 0 to 23. (e.g., ha set -I -H 12)
-D: Day. Setting range is from 0 to 30. (e.g., ha set -I -D 15)
760