Telnet Command: Srv Nat Openport - Draytek VIGOR2925 SERIES User Manual

status
E x a m p
E x a m p
> srv nat ipsecpass status
%% Status: IPsec ESP pass-thru and IKE src_port:500 preservation is
OFF.
T e l n e t C o m m
T e l n e t C o m m
This command allows users to set open port settings for NAT server.
srv nat openport n m [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
n
m
[<command>
<parameter>|...]
-a <enable>
-c <comment>
-i <local ip>
-w <idx>
-p <protocol>
-s<start port>
-e<end port>
-v
-r <remove>
-f <flush>
Vigor2925 Series User's Guide
source port (500) preservation.
It means to display current status for checking.
l e
l e
a n d : s r v n a t o p e
a n d : s r v n a t o p e
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means the index number for the profiles. The range is from
1 to 20.
It means to specify the sub-item number for this profile. The
range is from 1 to 10.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to enable or disable the open port rule profile.
0: disable
1:enable
It means to type the description (less than 23 characters) for
the defined network service.
It means to set the IP address for local computer.
Local ip: Type an IP address in this field.
It means to specify the public IP.
1: WAN1 Default,
2: WAN1 Alias 1,
Specify the transport layer protocol.
Available values are TCP, UDP and ALL.
It means to specify the starting port number of the service
offered by the local host. The range is from 0 to 65535.
It means to specify the ending port number of the service
offered by the local host.
The range is from 0 to 65535.
It means to display current settings.
It means to delete the specified open port setting.
remove: Type the index number of the profile.
It means to return to factory settings for all the open ports
n p o r t
n p o r t
...and so on.
678